Uncia dlp 3d printer software

Here is the place to discuss software and related tools for Slice generation, machine control, & etc...
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
carlsgems
Posts: 4
Joined: Tue May 05, 2015 7:27 pm
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable

Uncia dlp 3d printer software

Postby carlsgems » Thu Feb 04, 2016 3:19 pm

I have seen creation workshop for the uncia listed on the uncia forum and on this forum. The link that is listed and pasted in numerous forums is getting the good old 404 link not found. I have read the the sedwick software runs on the uncia but i am familiar with creation workshop and wanted to use it, the uncia website listed it and snapshot 2.01 as viable software. 3Dtree now host the current Creation workshop for a commercial application. Any news or up date on how to run creation workshop with the uncia? any help and direction would be greatly appreciated.

Thanks,

Carl

ThomasTedsmall
Posts: 2
Joined: Thu Dec 15, 2016 3:18 pm
Location: Belize
Contact:

Uncia dlp 3d printer software

Postby ThomasTedsmall » Mon Dec 19, 2016 6:53 am

Setting up a forum for my website, was wondering what forum software is best, It's quite a big community and I'll be using alot of plugins.
Any suggestions?
Thanks.


[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
[phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable