Page 1 of 1

Mysterious prints -image attached.

Posted: Tue Jun 02, 2015 1:33 pm
by yngsfan
Hi everybody!

I posted my printout last time. The problem was irregular line and I solved it.
The reason was precision of z axis.
Now I can printout long square pillar very clearly!

And now I am face with new problem...

http://postfiles10.naver.net/20150603_153/ruddlfrb_14332660645625cfis_JPEG/20150603_022251.jpg?type=w3

Did you noticed what is the problem?
1. I think the supports are enough to hold the model.
2. And the supports are very clean.
3. But the model has a irregular line.

This is the problem...OTL...
XY100 micron, Z resoludtion is 0.1mm.
Please help me!

Re: Mysterious prints

Posted: Wed Jun 03, 2015 8:40 am
by CihanAlak
The image cannot be viewed. Re post the image please.