Top-Down Resing floating on salt water
Posted: Thu Mar 19, 2015 8:21 am
In these days I have "fixed" (maybe I should say improve...) my calibration.
And now I'm doing some pretty prints.
Not perfect yet, but pretty.
This was done yesterday
First decent print afeter a simple cube
I want to go under so today I have cut in half the exposition time and try to print the same object.
In the plate there was 2 rings and 2 little owls (to see if the plate was really flat).
The owls come out really nice!
The rings on the contrary come out really bad...
The little support collapse on themself, like the tiny parts of the rings.
I suppose low exposition time, so I increase it to 3 sec now, and try to reprint the rings with some other object, a model take from thingiverse to compare the rings with a more massive items.
I'll post other photo as soon I can!
Advice or criticism are always welcome
And now I'm doing some pretty prints.
Not perfect yet, but pretty.
This was done yesterday
First decent print afeter a simple cube
I want to go under so today I have cut in half the exposition time and try to print the same object.
In the plate there was 2 rings and 2 little owls (to see if the plate was really flat).
The owls come out really nice!
The rings on the contrary come out really bad...
The little support collapse on themself, like the tiny parts of the rings.
I suppose low exposition time, so I increase it to 3 sec now, and try to reprint the rings with some other object, a model take from thingiverse to compare the rings with a more massive items.
I'll post other photo as soon I can!
Advice or criticism are always welcome