First prints!
Posted: Wed Aug 06, 2014 7:09 am
Hi,
Below some prints I made with my self designed SLA printer- BUT: so far I'm not satisfied with the quality so I hope someone can assist
1.) I've printed the orange helix at 0,05mm so I got my first successful print: the surface is nearly flat but the thickness of the helix poles varies
2.) the support nails always fail (white printed with 0,1mm)
I'm sure I do something wrong with exposure time but should I add more or less!?
######
Acer 6510BD
Aluminium bed vs. Silicone coated VAT
(FEP film for coating on the way...)
Makerjuice G+
app. 200 * 100 print area
very slow tilt and z rise
#####
Below some prints I made with my self designed SLA printer- BUT: so far I'm not satisfied with the quality so I hope someone can assist
1.) I've printed the orange helix at 0,05mm so I got my first successful print: the surface is nearly flat but the thickness of the helix poles varies
2.) the support nails always fail (white printed with 0,1mm)
I'm sure I do something wrong with exposure time but should I add more or less!?
######
Acer 6510BD
Aluminium bed vs. Silicone coated VAT
(FEP film for coating on the way...)
Makerjuice G+
app. 200 * 100 print area
very slow tilt and z rise
#####