fault any 1mm
Posted: Wed Jul 09, 2014 5:14 am
Hi,
i have a problem with my prints. Every 1mm i have on my test cube a "stair" (i don to know how to call it)
I have try exposure time between 1,5 an 10 sek. on 0,05mm and 0,1mm. I get the best result with 6sek. Also with anti aliasing on/off from 1,5x to 5x
I check the result when i´m printing test cubes and get a lock on the corner, below 6sek the corners are round. With 6sek they are sharp.
Did someone know where is the problem that i don't get constant the same layer?
i have a problem with my prints. Every 1mm i have on my test cube a "stair" (i don to know how to call it)
I have try exposure time between 1,5 an 10 sek. on 0,05mm and 0,1mm. I get the best result with 6sek. Also with anti aliasing on/off from 1,5x to 5x
I check the result when i´m printing test cubes and get a lock on the corner, below 6sek the corners are round. With 6sek they are sharp.
Did someone know where is the problem that i don't get constant the same layer?