Page 1 of 1
Saturn V Rocket
Posted: Thu Jul 03, 2014 8:15 pm
by Finhead
Another test for the Flex bottom VAT.
Total height is 144mm wall thickness on all parts of the model are .38mm
Printed at 72 micron XYZ with Makerjuice SubG+ 5.5 sec exposure time.
Re: Saturn V Rocket
Posted: Fri Jul 04, 2014 11:13 am
by PacManFan
Looks fantastic!
Re: Saturn V Rocket
Posted: Fri Jul 04, 2014 10:33 pm
by seasicksinbad
WOW!!! Congratulations! Looks great!
Re: Saturn V Rocket
Posted: Sun Jul 06, 2014 2:42 pm
by AndersonTa
finhead,
Do you have information about your "Flex Vat" somewhere? I'd like to know more.
Re: Saturn V Rocket
Posted: Mon Jul 07, 2014 10:01 am
by Finhead
Thanks guys, it has a bit of over cure but with the thickness on some parts it was the only way to have it finish properly.
Anderson I don't yet have information on the VAT since it was a quick "hacked" together piece, I had to use my adhesive back FEP as that is all I had here. It's not a ideal setup just yet, I am hopefully going to get some proper film before the end of July so I cam make a proper VAT. At that time I will for sure post up build pics and information.
Re: Saturn V Rocket
Posted: Wed Aug 06, 2014 1:43 am
by Craig Turley
@finhead - looks great!!
Re: Saturn V Rocket
Posted: Wed Aug 20, 2014 12:32 pm
by MichaelD33
Awesome! Do you have a printer build guide I could look at?