DETAILS LOSS :(
Posted: Thu May 15, 2014 6:43 am
Hi guys, got a problem and I need your help please.
Recently I got a pretty bad details loss on my prints.
I have FULL HD DLP, Optoma HD25e, 2800 luments, 20000 contrast, lamp 300 hours used.
distance to vat is 28 cm. I'm using MakerJuice SubG+ resin Black and Red with some added PI.
Focus is set properly, optics and vat are clean an clear.
With that config earlier I printed awesome stuff, but recently the details are so low - I would say it feel like the print has been blurred, or glossed,
awful feeling, precise details are gone ...
Question is that cannot it be related to software ZOOM, which is set to +10 on my DLP,
or can it be the CURE time, when the resin is overcuring in depth? Maybe Sharpness setting? Set to max ( 0 --> 15 )
Thanks a lot in advance,
Recently I got a pretty bad details loss on my prints.
I have FULL HD DLP, Optoma HD25e, 2800 luments, 20000 contrast, lamp 300 hours used.
distance to vat is 28 cm. I'm using MakerJuice SubG+ resin Black and Red with some added PI.
Focus is set properly, optics and vat are clean an clear.
With that config earlier I printed awesome stuff, but recently the details are so low - I would say it feel like the print has been blurred, or glossed,
awful feeling, precise details are gone ...
Question is that cannot it be related to software ZOOM, which is set to +10 on my DLP,
or can it be the CURE time, when the resin is overcuring in depth? Maybe Sharpness setting? Set to max ( 0 --> 15 )
Thanks a lot in advance,