Mysterious prints
Posted: Fri May 09, 2014 9:49 am
Hey,
I'm trying to enlarge my printer. But now I have mysterious results. My prints are skew and so I tried to figure out the problem. I build just the supports of a plate but the result looks not very nice.
The only idea I have is that the power of the projector concentrate on the middle because the higher supports form nearly a circle.
Does someone have problems like that or an idea to handle it?
I'm using a Viewsonic pjd7820hd with 3000 Lumen.
The shown plate is 100mm x 120mm but the projector exposed an area of 268mm x 161mm
Regards Toby
PS: Sorry for my bad english
I'm trying to enlarge my printer. But now I have mysterious results. My prints are skew and so I tried to figure out the problem. I build just the supports of a plate but the result looks not very nice.
The only idea I have is that the power of the projector concentrate on the middle because the higher supports form nearly a circle.
Does someone have problems like that or an idea to handle it?
I'm using a Viewsonic pjd7820hd with 3000 Lumen.
The shown plate is 100mm x 120mm but the projector exposed an area of 268mm x 161mm
Regards Toby
PS: Sorry for my bad english