Top Down Printing
Posted: Mon May 05, 2014 12:25 pm
I have had some success with top-down printing. Trying to avoid the whole vat coating issue.
This part took about 20 minutes to build at 0.1mm layer height, using MakerJuice Sub G+. I am very pleased with the resolution but I made the supports a little too big - I can't break them off without damaging the part. I'm now working on settling the resin more quickly between layers.
This part took about 20 minutes to build at 0.1mm layer height, using MakerJuice Sub G+. I am very pleased with the resolution but I made the supports a little too big - I can't break them off without damaging the part. I'm now working on settling the resin more quickly between layers.