Build Your Own SLA/SLS

another learning moment today. if the mirror is not absolutly clean.. it will create wierd print effects.. ugh!

hi hp_, i read 3 post ago you tried to print at 25u. have u build a part succesfully at this resolution? i am planing a rig with a 1080p projector with a flex vat to make jellewry parts, so print at 25u will be amazing . nice job!

hi sodium,

i think you will notice when using Creation workshop the results will be stunning.

here is a print on 0.1mm

0.1 layer height
150 mm/min up
6mm retract length
650 mm/min down

cheers,
hp

hi HP,

i just notice in another post you are using a camera ballhead to fix and adjust the mount plate. Is easy to adjust?

Hi Sodium,

it is very easy, the thing i was looking for was the load the ball head mount could take.. mine can take up to 8KG of load..

cheers,
hp

Hi HP

2 questions.

Are the prints above made using the flexvat you sell currently on your webshop ? and does it passive peel or do you have to attach the vat in a way that it can lift on 1 side ?

2nd question: what camera ballhead are you actually using ? I will need to buy one too


Kind regards

Bart
Belgium

Hi Bart,

the vat is fixed, the flex of he film causes the tilt on micro level.

if you want a ball screw joint, i have a few for sale

cheers,
HP

Hi!
congratulation about the prints!
i'm from turin too! where did you get your first surface mirror and the build platform? how much do they cost?

thank you

Hi,
this is my plate compilation created for Atum 3d.