Build Your Own SLA/SLS

Created an account just so I could show this to you guys.
http://www.instructables.com/id/homemad ... /?ALLSTEPS

looks promising, would something like this work at all with uv leds? if not what kind of modifications would it need?

also I'm a little under informed about gcode controlling the whole set up(motors) and with an lcd printer would you just display svg layers? you could even have a hand operated printer with no gcode, just display svg layers with a stopwatch and then turn a handle to raise/lower the build plate.

You're going to need a DLP projector generally. LCD's don't usually work well.
-S

http://bucktownpolymers.com/zve200-v470.html

I found this and it states: Sensitive enough to cure by the blue light from standard unmodified Pico and Pocket sized LED projectors.
so when you have a projector that can cure resin out of the box, the next step is getting the projector to display the right image. how is that done?