Build Your Own SLA/SLS

Hello everyone,
It is my first post.
I am building a SLA printer and I would like to use a galvanometer but I don't know witch kind of galvanometer, witch one, etc...
I have read it is possible to control that with Creation Workshop then I am very interested in with solution.

Someone can help me?

thank you

Math

You may want to take a look at this thread: and skip to the end. CW can support the LaserShark, but it's still in the initial stages of support. Why do you want to build a Galvo setup instead of a DLP based machine?

Hi,
thank you very much for your answer. I will use a Galvanometer because I will use a Laser
I think It could be better (in resolution) than a DLP.. Isn't it?