Page 1 of 1
DIY DLP resin printer with sliding y-axis for release
Posted: Sun Mar 23, 2014 1:29 am
by hp_
Hi everyone,
this one got posted on hackaday, and could be a very interesting read
cheers,
hp
Re: DIY DLP resin printer with sliding y-axis for release
Posted: Tue Mar 25, 2014 10:10 pm
by AndersonTa
The release is the similar method that was discussed in the research paper back in 2009. Def interesting, the immediate question is what the minimum displacement would be. Half the distance of the cross section? Half of the vat? Maybe its just a few mm's?
Re: DIY DLP resin printer with sliding y-axis for release
Posted: Fri Mar 28, 2014 7:53 pm
by johnrpm
I want to try ultrasonics or vibration to help release, maybe combined with a rotation action, but will not get time for a while.
Re: DIY DLP resin printer with sliding y-axis for release
Posted: Wed Jul 30, 2014 1:20 am
by 3dprinter.org.ua
Someone already tested an ultrasound?