creation workshop not slicing properly
Posted: Mon Oct 16, 2017 10:07 am
Does any have problems with CWS not slicing properly? If so, any suggestions?
More often than not we'll have to hit slice on a few occasions before we are happy to print, simply because the timings not right and the slice view shows 1 layer.
e.g trying to slice something that has 2447 layers, and it comes back with a time of 2hrs 22mins 22secs, when it should be closer to 48 hours, and slice view shows some layers.
hit slice again without making any changes, 12hrs 58mins but slice view only shows 1 layer
and so on
Getting very bored of CWS now
More often than not we'll have to hit slice on a few occasions before we are happy to print, simply because the timings not right and the slice view shows 1 layer.
e.g trying to slice something that has 2447 layers, and it comes back with a time of 2hrs 22mins 22secs, when it should be closer to 48 hours, and slice view shows some layers.
hit slice again without making any changes, 12hrs 58mins but slice view only shows 1 layer
and so on
Getting very bored of CWS now