Page 1 of 1
GRBL Homing ($H) problem
Posted: Sat May 16, 2015 12:58 pm
by CihanAlak
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 2:01 pm
by sodium
im not sure, but it seems the variable H just indicate the home position, in this case 0. it not send any command to execute, like g1, g28, etc ... anyway, had you tried send the command via manual gcode window¿?
i think is better to adjust z0 before press play button.
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 2:31 pm
by CihanAlak
When i send $h via manual code it goes limit switch and zeroing coordinate then start process.
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 4:21 pm
by sodium
;********** Header Start ********
;Here you can set any G or M-Code which should be executed BEFORE the build process
i think its self-explanatory
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 5:02 pm
by CihanAlak
I know i read that.
I write $H ;Go home and zero Z axis but
After slice, at g-code view .0 ;Go home and zero Z axis
Why "$H" turn to ".0" it is basic question and problem?
PacManFan what do you think about it?
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 7:27 pm
by PacManFan
Re: GRBL Homing ($H) problem
Posted: Sat May 16, 2015 10:56 pm
by CihanAlak
Really thank you i wll try that.
Best Regards
Cihan