Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

CW at dual-extruder FDM printer?

http://www.buildyourownsla.com/forum/viewtopic.php?f=5&t=2868

Page 1 of 1

CW at dual-extruder FDM printer?

Posted: Mon Apr 06, 2015 8:53 am
by Leinad78
hello guys,

does one know if its possible to drive a dual-extruder FDM printer (Replicator Dual) with Creation Workshop?
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/