Support generation software
Posted: Mon Jul 18, 2016 9:30 pm
Hi all,
My name is Bo, I am new to this forum. Currently I am looking for a support generation solution for my SLA printer, and I need some advise from all of you. I have the slicer, so I need a software can generate support, and export as .stl file.
I have tried Autodesk meshmixer, but I think the support have some issue with meshmixer (I use Ember setting, it generates too much useless support)
I also tried Magic on my friends computer(I dont have license), it is pretty good, but it's too expensive for me.
Is there any good support generation software you guys recommend? Thank you!
My name is Bo, I am new to this forum. Currently I am looking for a support generation solution for my SLA printer, and I need some advise from all of you. I have the slicer, so I need a software can generate support, and export as .stl file.
I have tried Autodesk meshmixer, but I think the support have some issue with meshmixer (I use Ember setting, it generates too much useless support)
I also tried Magic on my friends computer(I dont have license), it is pretty good, but it's too expensive for me.
Is there any good support generation software you guys recommend? Thank you!