XMaker software on diy DLP?
Posted: Mon Feb 15, 2016 7:58 am
Hello guys,
i just found the XMaker software for the M-One which is free and uses the ATMega2560. Unfortunally they don´t use Ramps, they developed their own hardware. Fortunally they seem to be using the same A4899 drivers like most of us use.
Does anyone tried using this software? It has a very nice hollow option which works extremely good
i just found the XMaker software for the M-One which is free and uses the ATMega2560. Unfortunally they don´t use Ramps, they developed their own hardware. Fortunally they seem to be using the same A4899 drivers like most of us use.
Does anyone tried using this software? It has a very nice hollow option which works extremely good