Only 1 layer printing
Posted: Mon Aug 24, 2015 8:32 am
Hi,
Yesterday I had my first run with latest Creation Workshop connected to Smoothieboard (default settings).
Manual controls work fine: Z movements were accurate.
When starting the job, it sends the first layer and freezes (time keeps running in the top right corner, but nothing happens) when Z starts to go up.
If I then don't stop to job, but go to manual control to move Z up - it sends the second layer...
Also tried with older Creation Workshops - same result.
Using the settings recommended for LittleRP https://vimeo.com/108978676
Any ideas?
Yesterday I had my first run with latest Creation Workshop connected to Smoothieboard (default settings).
Manual controls work fine: Z movements were accurate.
When starting the job, it sends the first layer and freezes (time keeps running in the top right corner, but nothing happens) when Z starts to go up.
If I then don't stop to job, but go to manual control to move Z up - it sends the second layer...
Also tried with older Creation Workshops - same result.
Using the settings recommended for LittleRP https://vimeo.com/108978676
Any ideas?