Build Your Own SLA/SLS

Hi pacman
i want to write my own firmware for cw bu i dont know what is the out put of your software.
i am not good at programming, so if you have any configured marlin or sprinter firmware for DLP printer set up please help me.

CWS will work "out of the box" with most firmwares -- it outputs pretty standard Gcodes.

Both Marlin and Sprinter work with CWS. You'll just need to configure your firmware to match your machine settings. Things like "steps per mm" and whether or not the endstops are enabled, etc.

That's not a whole lot of help, but without more details about your hardware, it's the best I can do...