Re: Drivers needed to controll mega 2560
Posted: Thu Jul 17, 2014 11:05 pm
YAY ITS FIXED
Ok so how did i fix it by adding 3 jumpers below the step stick
so after sitzme suggesting it was a step rate problem i had done a little research and voila i found post mentioning the jumpers under the stepper driver boards.
all the tutorials i have read regarding ramps set ups i have never seen mention of these jumpers nor was the ramps board shipped with jumpers, very frustrating,
now how do i make the steeper step faster hahahahahahah do remove one jumper or adjust the firmware??????
thank you to all that help
Ok so how did i fix it by adding 3 jumpers below the step stick
so after sitzme suggesting it was a step rate problem i had done a little research and voila i found post mentioning the jumpers under the stepper driver boards.
all the tutorials i have read regarding ramps set ups i have never seen mention of these jumpers nor was the ramps board shipped with jumpers, very frustrating,
now how do i make the steeper step faster hahahahahahah do remove one jumper or adjust the firmware??????
thank you to all that help