Build Your Own SLA/SLS

Hi guys, I need to increase my printing (scanning) speed and tried to change feed rate in slic3r but there is no change in speed at all..
laser beam moves with the same speed although I increased feed rate from 600 to 5000 but no change...

Have you ever experienced this problem? I need to know the method of scanning speed increase..

and I changed scanning segment from 0 to 1, and the beam disappears from my printing region...

How can I increase my printing speed with Marlin + Slic3r + Repetier host programs?

Thanks!

Which printer are you using? What software?

Hi, I made the H/W by myself, similar with Form1 design. and I am using Marlin + Slic3r + Repetier-host.

Alright,
What software are you using to driver your hardware. This is laser based? X/Y Cartesian or Galvo based?

Steve, I believe he is asking about his Galvo based setup.