Page 2 of 2
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Sep 03, 2015 12:56 pm
by nc42
Sounds like you don't have a "first surface" mirror. That's where the reflecting surface is on the outside not under the glass.
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Sep 03, 2015 1:36 pm
by hefeglass
you could try making it into a first surface mirror...found this video on youtube:
https://www.youtube.com/watch?v=IaEaaeajCSI
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Sep 03, 2015 1:46 pm
by nalmeida
I was precisely investigating this option, will try it tomorrow. Thanks.
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Sep 10, 2015 9:03 am
by nalmeida
Building is finished, here are my first prints. I'm using a home made first surface mirror so quality might get better with the one I bought from Brad.
I'm using Spot A GP resin, the mix for the B9 and results are encouraging so far. I had some problems with base adhesion and I'm working on that right now. Yellow is not that great to photograph but here it is:
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Sep 10, 2015 9:04 am
by nalmeida
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Mon Dec 21, 2015 3:37 am
by firecardenal
good job.
could you share plans or measures to make equal?
Thanks
Re: [BUILD] My LittleRP clone "Snow White"
Posted: Thu Dec 24, 2015 2:55 pm
by nalmeida
All the plans and schematics can be found here:
http://www.littlerp.com