Build Your Own SLA/SLS

Hi,

Does anyone have experience with using the B9R-1 Castable resin successfully on a littleRP kit? I've tried a few times and my models coming out as "blobs". I used the same settings (using the CW video: https://vimeo.com/108978676) as when I printed using the Makerjuice resin and that model came out fine. Any advice on the best choosing the right exposure and CW settings?

Any advice helps. Thanks!

Any pics of the blobs? are the blobs bigger or smaller than the model size.

If it is a small blob ie. only the large crosssection areas cured and none of the smaller details the curetime will need to go up, if it is a big blob ie. a print with lots of bleeding to the point where everything melds together the curetime will need to go down.

I believe in general the b9 resins cure much slower.

Any advice on what I should use for the settings (top exposure, bottom exposure, lift speed, etc.)? I'm a beginner at printing so any additional explanation will help a ton. Thanks for the help!

Here is the image: http://imgur.com/G3h37wy
I stopped it at about 75% completion since it obviously wasn't working.

Hi LittleRP users! Any advice here would be great!

Longer cure time, the B9 stuff is pretty slow compared to other resins.