Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

Improvement Hack: Auto-align “No Twist” Build Plate Space

http://www.buildyourownsla.com/forum/viewtopic.php?f=19&t=2613

Page 1 of 1

Re: Improvement Hack: Auto-align “No Twist” Build Plate Spac

Posted: Thu Apr 09, 2015 4:55 pm
by cerriousdesign
Fantastic! I don't have a filament 3D printer, but I can get them done a couple places in town I think or at shapeways.
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/