Page 1 of 1
Board firmware please
Posted: Thu Oct 16, 2014 4:08 pm
by partsoven
Can someone post the firmware for the LittleRP? My arduino seems to have taken a crap and I would like to try reflashing it.
Re: Board firmware please
Posted: Thu Oct 16, 2014 4:26 pm
by partsoven
Nevermind... connected to it via Arduino software and it spit out GRBL .80 and looks like I need to switch my baud inside of Creation Workshop to 9600.
Re: Board firmware please
Posted: Thu Oct 16, 2014 4:33 pm
by goopyplastic
9600 baud is the GRBL default, however newer versions of GRBL .9 etc. will use a higher baud rate.
Re: Board firmware please
Posted: Wed Mar 11, 2015 2:52 pm
by That_Guy
Could you please post a link to the firmware
Re: Board firmware please
Posted: Wed Mar 11, 2015 3:58 pm
by PomeroyB
Re: Board firmware please
Posted: Wed Mar 11, 2015 6:01 pm
by goopyplastic
I ship with:
https://github.com/downloads/grbl/grbl/ ... z_9600.hex.9 should work fine, but you will need to change / check the settings after uploading as the eeprom settings change.
Re: Board firmware please
Posted: Sun Mar 15, 2015 5:54 pm
by That_Guy