Build Your Own SLA/SLS

Sounds like you don't have a "first surface" mirror. That's where the reflecting surface is on the outside not under the glass.

you could try making it into a first surface mirror...found this video on youtube:

https://www.youtube.com/watch?v=IaEaaeajCSI

I was precisely investigating this option, will try it tomorrow. Thanks.

Building is finished, here are my first prints. I'm using a home made first surface mirror so quality might get better with the one I bought from Brad.

I'm using Spot A GP resin, the mix for the B9 and results are encouraging so far. I had some problems with base adhesion and I'm working on that right now. Yellow is not that great to photograph but here it is:

I'm using just 1.5 anti aliasing in the settings.

good job.
could you share plans or measures to make equal?

Thanks

All the plans and schematics can be found here:

http://www.littlerp.com