Pegasus Touch + Open Source firmware
Posted: Sat Oct 29, 2016 7:20 pm
I'm working on some open source firmware for my Pegasus Touch. Any geeky folks want to help give it a try with me? I have some success on my prints, but had to rewrite my code base (good timing because I also had to recoat my vat at the same time, but also bad because I goofed up cleaning it and it is all clouded up). I'm working on an alternative VAT, but until then I likely won't do too much more work on the code base. I'd help anyone willing to give it a shot get it up and running and tweak any issues that you find.
Note: I use slic3r to slice models and my code takes in the gcode file (ini file in the repo below), also I've only tested it with Make Juice G+ Red resin. The calibration settings for the laser are based on my old code, which may or may not print well with the current settings. I'm also theorizing that I might be over exposing because I was under the impression the laser spot size was ~80 microns, but I'm reading on an number of other forums that it might be ~240 microns.
https://github.com/doobie42/OpenPegasus
Note: I use slic3r to slice models and my code takes in the gcode file (ini file in the repo below), also I've only tested it with Make Juice G+ Red resin. The calibration settings for the laser are based on my old code, which may or may not print well with the current settings. I'm also theorizing that I might be over exposing because I was under the impression the laser spot size was ~80 microns, but I'm reading on an number of other forums that it might be ~240 microns.
https://github.com/doobie42/OpenPegasus