Page 1 of 1
my FlexVAT
Posted: Wed Nov 05, 2014 7:32 pm
by Kvirre
I would like to share my construction for a flexible VAT ....
Re: my FlexVAT
Posted: Thu Nov 06, 2014 7:21 am
by Hugues
Thanks for sharing.
But I'm not entirely sure how it's actually flexing. If you have time, could you post a short video ?
Re: my FlexVAT
Posted: Fri Nov 07, 2014 2:36 pm
by Kvirre
Re: my FlexVAT
Posted: Fri Nov 07, 2014 6:19 pm
by farmermac
Great job. Nice tight design. 2 questions:
1. I am assuming that the FF printed parts are ABS?
2. Is there any issue with the resin in contact with the side wall part?
Thanks,
farmermac
Re: my FlexVAT
Posted: Fri Nov 07, 2014 6:45 pm
by AndersonTa
Re: my FlexVAT
Posted: Sat Nov 08, 2014 6:08 am
by Kvirre
Re: my FlexVAT
Posted: Sat Nov 08, 2014 10:33 pm
by MrBaz
Re: my FlexVAT
Posted: Sun Nov 09, 2014 5:46 am
by EdgE
Nice design, tnxs for posting
Also your printer is looking very stable.
And above all, it's printing very well.
Nice job.
Re: my FlexVAT
Posted: Sun Nov 09, 2014 3:03 pm
by Kvirre