Adding I2C display to Ramps
Posted: Mon Apr 04, 2016 3:50 am
Hi,
I would like to add a small display to ramps ()
Here I would like to show remaining buildtime from CW ...
Is this possible to do easily?
Or does it require a whole lot of programming / rewrite of both CW and Marlin FW.
I was thinking a custom gcode command to set and display the time.
(If I can retrieve the buildtime from CW that is)
I would like to add a small display to ramps ()
Here I would like to show remaining buildtime from CW ...
Is this possible to do easily?
Or does it require a whole lot of programming / rewrite of both CW and Marlin FW.
I was thinking a custom gcode command to set and display the time.
(If I can retrieve the buildtime from CW that is)