Page 2 of 2
Re: Makerjuice Waxcast.
Posted: Fri Jun 24, 2016 1:37 pm
by sgraber
Re: Makerjuice Waxcast.
Posted: Fri Jun 24, 2016 7:20 pm
by hirenashra
Re: Makerjuice Waxcast.
Posted: Sat Jun 25, 2016 4:02 pm
by chill74
Re: Makerjuice Waxcast.
Posted: Sat Jun 25, 2016 4:46 pm
by HTL
take a look at this post:
Also, you may want to try this utility for exposure testing:
Re: Makerjuice Waxcast.
Posted: Wed Jun 29, 2016 4:46 pm
by hirenashra
Re: Makerjuice Waxcast.
Posted: Wed Jun 29, 2016 6:41 pm
by chill74
No, the shrinkage might be 0.5% or so. If your print is that much smaller, it means you need to calibrate your print software. Do you use CW?
Re: Makerjuice Waxcast.
Posted: Wed Jun 29, 2016 7:28 pm
by hirenashra