Build Your Own SLA/SLS

A forum dedicated to helping you build your own SLA/SLS-based 3d printer
http://www.buildyourownsla.com/forum/

best resin to start off with

http://www.buildyourownsla.com/forum/viewtopic.php?f=13&t=2735

Page 1 of 1

best resin to start off with

Posted: Sun Mar 01, 2015 3:25 pm
by nicanor76
What's the easiest resin to start with for a newbie, I'm assuming Maker Juice G+ is a safe bet to use first to dial in a new printer build?
All times are UTC-04:00
Page 1 of 1
Powered by phpBB® Forum Software © phpBB Limited
https://www.phpbb.com/