Basic Tutorial
Posted: Sun Mar 22, 2015 3:33 pm
Hey guys -
Im just getting into this. I have done FFF 3D printing for over 3.5 years and ready to try something new.
Ive read through some posts and noticed theres no "standardized" tutorial for building a SLA printer.
Im thinking of something like when the Prusa Reprap came out - it was more or less the same basic design and was good
for a beginner to start with and modify from. Theres almost too much info here that contradicts one another.
So as a beginner, whats the best, easiest, and most user friendly design to start with? Id like something basic to get my feet wet.
Any recommendations on a good "fool proof" design?
and maybe the closest thing to plug and play projector.
Thanks!
Jeff
Im just getting into this. I have done FFF 3D printing for over 3.5 years and ready to try something new.
Ive read through some posts and noticed theres no "standardized" tutorial for building a SLA printer.
Im thinking of something like when the Prusa Reprap came out - it was more or less the same basic design and was good
for a beginner to start with and modify from. Theres almost too much info here that contradicts one another.
So as a beginner, whats the best, easiest, and most user friendly design to start with? Id like something basic to get my feet wet.
Any recommendations on a good "fool proof" design?
and maybe the closest thing to plug and play projector.
Thanks!
Jeff