I built my DLP SLA printer from scratch and have had multiple successful prints with it. Atm i am waiting on some adhesive backed FEP foil to make sure the printing is a bit more robust than when using Sylgard 184.
Now the question i wanted to ask was:
What are the minimum system requirements to run Creation Workshop and to make sure no hiccups pop up when slicing or running a print?
The reason i am asking is i am planning on buying a very cheap laptop as a dedicated Printer Workstation and since going cheap means going low on the specs side, i just wanted to make sure how cheap i could go without sacrificing reliability. In case it matters i am using an Arduino with a modified Version of hlocke's Firmware.
Cheers and would really appreciate some help
![Wink ;)](./images/smilies/icon_e_wink.gif)