The 3d print is 86mm X 70mm X 19mm without the supports. The layers you see are 0.1mm thick.
technical details can be found at http://projectsinterestsandetcetera.com/
photos of a 3d print made on my updated printer
-
- Posts: 52
- Joined: Mon Jan 13, 2014 7:34 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: photos of a 3d print made on my updated printer
Clean print! I'd be curious to see the underside once the supports are removed. Usually the underside of prints (the sides facing the build plate) tend to get a little bumpy from the resin not curing at consistent depths. A problem I hope can be solved with better resins in the future.
Thanks for sharing!
Thanks for sharing!
-
- Posts: 301
- Joined: Tue Dec 24, 2013 10:25 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: photos of a 3d print made on my updated printer
Hi HTL,
I read your blog with much interest!
very nice blog, and nice print,
the light source in you projector is not UV is it?
Cheers,
hp
I read your blog with much interest!
very nice blog, and nice print,
the light source in you projector is not UV is it?
Cheers,
hp
Re: photos of a 3d print made on my updated printer
No, the projector light source is not uv. The projector is a totally unmodified (with the exception of a +4 closeup lens for close focusing) toshiba T95.
-
- Posts: 277
- Joined: Fri Jan 31, 2014 12:56 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: photos of a 3d print made on my updated printer
So your curing the resin with the color wheel intact and fully untouched projector (besides the lenses). Thought that wouldn't work properly?
- 258cj7
- Posts: 31
- Joined: Mon Jan 06, 2014 9:38 pm
- Location: Kentucky, USA [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: photos of a 3d print made on my updated printer
I'm also using a projector with the color wheel intact. The only mod was to the focus ring. Cure time for MakerJuice SubG+ is 5.5 seconds.
Mitsubishi XD430U 1024x768 native 230w UHP bulb
Mitsubishi XD430U 1024x768 native 230w UHP bulb