Getting there.
Posted: Fri May 16, 2014 10:46 pm
Legend of Zelda's Crest of Hyrule.
Lesson I learned on this print: Never print the part directly on the build surface. ALWAYS use supports. I broke one of the wings when using blade to peel it from the glass. Also since the part is directly attached to the build surface, the first layers will be over exposed and will create an edge.
Lesson I learned on this print: Never print the part directly on the build surface. ALWAYS use supports. I broke one of the wings when using blade to peel it from the glass. Also since the part is directly attached to the build surface, the first layers will be over exposed and will create an edge.