Hello,
I had an 4 inch screen and a Raspberry Pi of which I did not know what to do then I made one LCD SLA 3D Printer !
I was inspired a lot by the work of Ionel Ciobanuc
Description :
4 inch LCD Screen
Raspberry Pi 3
Arduino Mega & RAMPS 1.4
ProjectLayer
50 W 405nm LED
Parameters :
- Layer Thickness = 0.1mm
- Cure Time = 12 seconds
- Lift 20mm
- FunToDo Snow White Resin
The principle is so simple but the development, a little less!
Thank you all !!!
Jled.
LCD SLA 3D Printer 50W LED
-
- Posts: 2
- Joined: Thu Nov 16, 2017 4:39 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: LCD SLA 3D Printer 50W LED
How are you switching the 50W leds on/off ?
-
- Posts: 2
- Joined: Mon Aug 28, 2017 9:47 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: LCD SLA 3D Printer 50W LED
Hello,
I use a relay connected to fan output and I command light on/off with gcode command m106 et m107.
I use a relay connected to fan output and I command light on/off with gcode command m106 et m107.
-
- Posts: 1
- Joined: Wed Dec 13, 2017 6:26 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: LCD SLA 3D Printer 50W LED
Cool dragon!