DIY DLP printer + FEP foil / Utrecht
Posted: Mon Jan 27, 2014 4:31 pm
I was inspirited by a nice movie from Oliveira Jose about a DIY SLA 3D printing device.
This should be my next project!
I didn't want to just copy/paste, I designed the setup a little different:
Top-Down & Bottom-Up in one design & having a smaller footprint, using 2 mirrors:
After about 300 hours of building, this results into the next 'working' design:
Click the picture above for my building blog.
Right now I'm still in a testing phase.
It's still difficult to print something right...
I'm using PDMS, but that will perish also, especially after over-exposure (due to resin left on the vat).
This should be my next project!
I didn't want to just copy/paste, I designed the setup a little different:
Top-Down & Bottom-Up in one design & having a smaller footprint, using 2 mirrors:
After about 300 hours of building, this results into the next 'working' design:
Click the picture above for my building blog.
Right now I'm still in a testing phase.
It's still difficult to print something right...
I'm using PDMS, but that will perish also, especially after over-exposure (due to resin left on the vat).