I decided to go with a quick release to allow the printer to go from a DLP to Galvo/Laser configuration. Takes less then 5 minutes to switch.
Also created a desk/table off the main printer body for the laptop which has come in handy
![Smile :)](./images/smilies/icon_e_smile.gif)
![Image](http://venture-labs.co/images/IMG_0095.jpg)
![Image](http://venture-labs.co/images/IMG_0093.jpg)
Laser/Galvo Setup
![Image](http://venture-labs.co/images/IMG_0114.jpg)
![Image](http://venture-labs.co/images/IMG_0116.jpg)
Adjustable Arm
![Image](http://venture-labs.co/images/IMG_0119.jpg)
![Image](http://venture-labs.co/images/IMG_0122.jpg)
Bill A