Hi All !
I want to report a little frustrating experience I had with my ramps... at some point the stepper motor was not working anymore properly, like they had no enough torque...some noise and little random movement .
So i tried ne stepper driver , recable ecc... no result, but then I accidentally pressed the button reset and.. Yhee ! Now they work again !!
So if you have this kind of problem, just press reset ( on the side of the RAMPS) reconnect and go
But I still have this problem quite a lot, usually happen on the end of a print... Somebody know why this can happen ??
Ciao !
Ramps1.4 Problems Motor.. Solved..In Part....
-
- Site Admin
- Posts: 126
- Joined: Wed Oct 22, 2014 3:18 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: Ramps1.4 Problems Motor.. Solved..In Part....
Sounds like an over heating stepper driver. Do you have the heat sinks on and good air flow?
-
- Posts: 12
- Joined: Wed Jan 21, 2015 4:05 am
- Location: München Germany ... But from Italy [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: Ramps1.4 Problems Motor.. Solved..In Part....
Hi nc42 !
I actually have only the standard little sink, but I use a Nema 23 maybe could be a over heating I will put a fan over to check
I actually have only the standard little sink, but I use a Nema 23 maybe could be a over heating I will put a fan over to check