Feature Request - TopDown printers
Posted: Thu Jul 24, 2014 9:10 am
Hi,
Would be nice if there was a Z-axis compensation-parameter, for the top-down printer systems
To compensate for the linear amount of displacement of resin, as the Build-platform descends bellow the surface.
This compensation could be expressed as : XX mm / mm (retract XX mm for each mm on Z axis movement after homing)
| |
| | <- Rods (known diameter / volume)
| |
| |
--------------- <- Resin surface
| |
| |
============ <- Build platform
Would be nice if there was a Z-axis compensation-parameter, for the top-down printer systems
To compensate for the linear amount of displacement of resin, as the Build-platform descends bellow the surface.
This compensation could be expressed as : XX mm / mm (retract XX mm for each mm on Z axis movement after homing)
| |
| | <- Rods (known diameter / volume)
| |
| |
--------------- <- Resin surface
| |
| |
============ <- Build platform