must see ifno needed
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
must see ifno needed
ok so here the dealio build my top down and all working with a small odd problem..ok I put the projector on top and made a cube 10mm x 10mm x 10mm moved the build plate till cube from projector was aproxx 10 x 10 mm so did a test print and.......sweet came out 10 x 10 x 15.7 ...so when online used the http://prusaprinters.org/calculator/ and got..2560.00 Click to Share! 1.25 1.8° 1/16th 1 : 1 so I put 2560 in sprinter instead of the 3200 that was there...did another print and cool 10 x 10 x14.2 ok now getting lost?....so I marked the 8mm smooth shaft on my z axis and in cw moved it down 10mm checked at it was 13.36 not the 10mm..........I have no CLUE HERE heres my set up ramps 1.4 arduino 2560 nema 17 8mm lead screw from purisa i3......
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: must see ifno needed
ohhh also cw can not set my projector to 1920 x1080 ....only shows as 1280 x 720 its the acer h6510bd
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: must see ifno needed
well I think I got it .... had to trick sprinter into believing I was using 5/16 and not 8 mm and bam .4 off not to bad 10.41mm
-
- Posts: 13
- Joined: Sat Jun 06, 2015 11:17 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: must see ifno needed
that's what I used everything working great..... just have to find the happy medium on the first layer a few times now I over cooked the first layer at 6000 ...but cure time for every other layer is 2000