Titan1 from Kudo3d.com - first good print
Posted: Sun Feb 22, 2015 1:45 pm
Hi guys,
thought i'd share this one, i receive my Titan1 from Kudo3d.com 2-3 weeks ago and after some trials and errors i managed to get a couple of good prints now, pictures below,
Sliced with CW (thanks Pacmanfan !) at 50 microns and antialiasing set at 3.5, printed at 100XY with Funtodo Ind Blend with some carbon black pigment from Pearlex,
The printer works fine. The flexvat is now under control, but i had quite a lot of failed prints, and i'm not sure how long it will last, it is spec'ed for 50 prints. I'm planning to build a FEP flexvat probably.
All in all, i'm quite happy with the outcome.
thought i'd share this one, i receive my Titan1 from Kudo3d.com 2-3 weeks ago and after some trials and errors i managed to get a couple of good prints now, pictures below,
Sliced with CW (thanks Pacmanfan !) at 50 microns and antialiasing set at 3.5, printed at 100XY with Funtodo Ind Blend with some carbon black pigment from Pearlex,
The printer works fine. The flexvat is now under control, but i had quite a lot of failed prints, and i'm not sure how long it will last, it is spec'ed for 50 prints. I'm planning to build a FEP flexvat probably.
All in all, i'm quite happy with the outcome.