Re: Kast 3DP (LCD Based?)
Posted: Thu Oct 02, 2014 11:11 pm
Im not really doubting their speed, I can nearly do that fast if I can do a quicker release. You can cure resin on my monochrome LCD to 0.1mm in about 1-1.5 seconds if you really crank up the wattage on the LED's
Im skeptical as to the models and printed parts they have shown so far.. on 3ders they have a picture of a lens that was supposedly printed on the machine.. Ive yet to see any machine (minus the very expensive and high tech luxexcel) that can produce perfectly clear lenses, How do they do it if its printing in layers? there is a defined XY resolution of 96 microns, there should be clearly visible steps or layers on the lens surface.
Also, Ive only seen renderings of the machine, never an actual machine, and the other printed parts are just the same parts they have shown several months ago. You're telling me that in 5 months since they announced it they haven't printed any more sample parts?
Perhaps they are holding back till the kickstarter campaign, but something just doesn't seem right. Hopefully they will clear that up soon. I'd love to get my hands on one.
Im skeptical as to the models and printed parts they have shown so far.. on 3ders they have a picture of a lens that was supposedly printed on the machine.. Ive yet to see any machine (minus the very expensive and high tech luxexcel) that can produce perfectly clear lenses, How do they do it if its printing in layers? there is a defined XY resolution of 96 microns, there should be clearly visible steps or layers on the lens surface.
Also, Ive only seen renderings of the machine, never an actual machine, and the other printed parts are just the same parts they have shown several months ago. You're telling me that in 5 months since they announced it they haven't printed any more sample parts?
Perhaps they are holding back till the kickstarter campaign, but something just doesn't seem right. Hopefully they will clear that up soon. I'd love to get my hands on one.