Hi,
This is my very first 3d printing project.
i try to calibrate 1cm cube with 100micron xy resolution.
i used optoma EX536 (Native Resolution : 1024x768) my build size should be 102.4x76.8 mm
but the build size is 144x108 mm!! in CreationWorkshop output resolution is 141microns
i measure the cube on build area everything ok,1 cm.
when i try to make build size 102.4x76.8 mm but cube bigger than it should be and blur(the focus ring's limited).
what should i do?
Regards
Koom
projector resolution problem
Re: projector resolution problem
All I can think of is to try putting a spacer somewhere in the output lens array. Most projectors need a spacer of some kind to focus to a small area.
I prefer to know nothing about everything rather than everything about nothing.
-
- Posts: 5
- Joined: Wed Jul 15, 2015 11:55 pm [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: projector resolution problem
Thank you,James.
I'll try it
Koom
I'll try it
Koom