Bottom up design, 90degree angle or straight
Posted: Wed Jun 22, 2016 4:23 pm
I am just about to build my first DLP printer, I have never seen one so I try to read up on it. I have all the components and only need the cabinet.
I have had a very hard time reading up on this, because much changes over time. I have decided on a bottom up with a flexivat approach, I build in active tilting. If this is a stupid idea, please tell me now.
Regarding the design, all I find has the projector in a 90 degree angle and a mirror. Why do that? why not just straight on without a mirror? does the flexivats / fep film break sometimes, so that the projector gets soaked? or is it to save space?
I have had a very hard time reading up on this, because much changes over time. I have decided on a bottom up with a flexivat approach, I build in active tilting. If this is a stupid idea, please tell me now.
Regarding the design, all I find has the projector in a 90 degree angle and a mirror. Why do that? why not just straight on without a mirror? does the flexivats / fep film break sometimes, so that the projector gets soaked? or is it to save space?