Hi, that's great development,
What is the focus lens size do you use with optoma hd37?
Did you make any mods on it?
I can't get any good results of it on littlerp1 and it takes a lot of time to cure one layer.
Search found 21 matches
- Thu Mar 30, 2017 6:43 am
- Forum: LittleRP
- Topic: LittleRP2 Information
- Replies: 85
- Views: 153523
- Fri Nov 25, 2016 12:46 pm
- Forum: General
- Topic: SLA Problems Survey l $5 amazon gift card inside (closed)
- Replies: 2
- Views: 15802
- Fri Nov 25, 2016 10:48 am
- Forum: General
- Topic: SLA Problems Survey l $5 amazon gift card inside (closed)
- Replies: 2
- Views: 15802
SLA Problems Survey l $5 amazon gift card inside (closed)
Hi,my name is Mohamed. I'm a member of a startup team. We are under the supervision of Bedaya Center http://www.gafisme-bedaya.com/ , General Authority of Investment in Egypt. I need your help to know some information about problems that we all face in SLA 3D Printing. It will take less than 5 minut...
- Sat Jul 09, 2016 8:20 pm
- Forum: General
- Topic: Bottom up design, 90degree angle or straight
- Replies: 1
- Views: 12800
Re: Bottom up design, 90degree angle or straight
of course you can go for the direct setup and don't use the mirror. the fep film might be cut, but it's according to your usage like if you use sharp tools to clean it.
- Sun Apr 24, 2016 6:52 pm
- Forum: General
- Topic: My model was surplus on top.
- Replies: 1
- Views: 15228
Re: My model was surplus on top.
I think it's overcured try to decrease the exposure time.
- Wed Apr 06, 2016 8:24 pm
- Forum: Hardware
- Topic: Help Z-Axis Calibration because I am so lost?
- Replies: 4
- Views: 14284
Re: Help Z-Axis Calibration because I am so lost?
I think it's a firmware problem, try to re-calibrate the z steps per mm
- Mon Apr 04, 2016 9:46 am
- Forum: Hardware
- Topic: WHAT is going on? why? help please
- Replies: 4
- Views: 15106
Re: WHAT is going on? why? help please
I think you just need to add more pigment.
- Thu Mar 31, 2016 11:10 am
- Forum: Display Devices
- Topic: Datatree 3D
- Replies: 1
- Views: 12926
Datatree 3D
did any one tried the datatree 3d UV Light engines?
what's the difference between LED UV and the normal projector lamp?
what's the difference between LED UV and the normal projector lamp?
- Mon Mar 28, 2016 3:17 am
- Forum: Hardware
- Topic: WHAT is going on? why? help please
- Replies: 4
- Views: 15106
Re: WHAT is going on? why? help please
What resin do you use??
looks like the B9C yellow resin?
looks like the B9C yellow resin?
- Sun Jan 24, 2016 4:51 pm
- Forum: LittleRP
- Topic: First layer sticks to flexvat instead of build plate. Help.
- Replies: 2
- Views: 7690
Re: First layer sticks to flexvat instead of build plate. Help.
the same happened with me, it's all about the "Z Lift Distance" and the "Z Lift Speed" , try to make them lower. I think that in lift distance it would be better <5mm and the lift speed to be <100 mm/m