We took the easy route, due to time constraints, and ordered a NEMA 23 stepper. Works great with the RAMPS as expected! I had one small hiccup, since the bolt configuration of the NEMA 23 oddly didn't match the configuration on the Vexta motor we replaced; however, making a plate to accommodate this only took a few hours - will try it out the full assembly tomorrow. We also ordered a different coupler due to a smaller shaft size - $5.
Time-permitting, I'd still like to control the Oriental Motor CRK-Series stepper driver with the RAMPS 1.4 if possible. This way, we could take advantage of the motor's resolution and torque capabilities. It's the Pentagonal wiring configuration that's throwing me off - found .
Thanks again.Statistics: Posted by WorkerBee — Wed Jun 10, 2015 11:03 pm
]]>