It turns out I'm an idiot.
I wasn't clicking the apply button. I'd gotten used to clicking it in the slicing config but not the machine config, whoops. I'm getting good, properly scaled prints now, I do have odd lines running through a couple of layers but I think I've derailed this thread enough and I'll make a new thread, thanks for your help.
Statistics: Posted by Vulwulf — Fri May 19, 2017 9:49 am
]]>
]]>
]]>
]]>
]]>
]]>
]]>
]]>
I'd love some help setting up my littlerp for 25 micron in general, i'm a newbie to all of this, I have a acer x152h in the forward position and im using makerjuice waxcast. Used the old information videos on Vimeo as a guide but changed what I thought was right for my projector.
Settings:
Statistics: Posted by Vulwulf — Sun May 14, 2017 1:01 pm
]]>