Well... Here's my work in progress so far. Top down DLP portion is working like a charm. Looking forward to moving forward on the Lasershark portion soon.
I decided to go with a quick release to allow the printer to go from a DLP to Galvo/Laser configuration. Takes less then 5 minutes to switch.
Also created a desk/table off the main printer body for the laptop which has come in handy Next on the list is enclosing it and adding a hinged door on the front.
Laser/Galvo Setup
Adjustable Arm
Bill A
DLP/LASER 3D Printer Build - Top Down
-
- Posts: 116
- Joined: Wed Jun 25, 2014 4:20 pm
- Location: SW Michigan [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: DLP/LASER 3D Printer Build - Top Down
Bill,
Where did you get the adjustable clamp/tube hardware?
Where did you get the adjustable clamp/tube hardware?
Dan - mUVe 1 DLP
-
- Posts: 30
- Joined: Sat Aug 16, 2014 10:32 am
- Location: Berlin, Germany [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: DLP/LASER 3D Printer Build - Top Down
Looks like camera (DSLR) rig parts to me.
And that's a lovely build
And that's a lovely build
-
- Posts: 37
- Joined: Wed May 21, 2014 10:29 pm
- Location: Novi, MI [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: DLP/LASER 3D Printer Build - Top Down
Correct on the DSLR rig parts for the adjustable clamp/tube hardware.
Purchased it from here: http://www.ginirigs.net
Purchased it from here: http://www.ginirigs.net
-
- Posts: 140
- Joined: Tue Jun 24, 2014 8:14 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: DLP/LASER 3D Printer Build - Top Down
What would be the benefit of going for laser-version vs. DLP?
(except for the bulky size of the projector)
(except for the bulky size of the projector)
-
- Posts: 1
- Joined: Fri Oct 17, 2014 3:00 am [phpBB Debug] PHP Warning: in file [ROOT]/vendor/twig/twig/lib/Twig/Extension/Core.php on line 1266: count(): Parameter must be an array or an object that implements Countable
Re: DLP/LASER 3D Printer Build - Top Down
wow. that is a lovely build, is that printed by the SLA? I found this technology is high-tech. I have printed my stuff before.